Structure principle of corn peeling machine: The machine is mainly composed of frame, feeding hopper, drum and outlet. The raw material enters the drum chamber through the inlet, the drum body strips the corn husk by rotation, friction, extrusion and transmission, and the corn husk and cob are automatically removed from the corresponding outlet. Said motor is mounted on a power block, said drive shaft is mounted on a bearing block, said drive shaft is connected to said motor by means of a belt, said drive shaft is provided with a spiral and rubber spikes, said drive shaft is connected to said drive shaft by means of a gear, said drive shaft is provided with a number of rubber wheels, said rubber wheels are provided with raised bushings. The bearing blocks at both ends of the drive shaft are not on the same level. Thanks to the spiral belt and rubber spikes provided on the drive shaft, which is provided with a number of rubber wheels, the drive and drive shafts work in synergy and the peeling device is able to evenly place the lugs entering the machine. It is distributed between two pairs of relatively rotating peeling rollers and advances smoothly with the rotation of the ear body. In the process, the bracts are torn by special peeling claws and the rotating rollers immediately pull the bracts down to complete the peeling.