The difference is not very big, the working principle is the same, the production of breeding feed kind of particles in the diameter of about 2-5 mm, very fine kind, biomass pellet fuel diameter mostly in 8-10 mm, the mill is not the same, now many of our peers are directly with biomass pellet fuel machine to do cattle and sheep feed pellets, with a diameter of 8 mm mill, the yield is still very high, out also fast, cattle and sheep eat also The same.

Biomass pellet mill: do wood pellets generally need high pressure, high stability, good heat dissipation, can run a long time pellet mill, the general market is commonly used pellet mill is vertical ring die pellet mill and horizontal ring die pellet mill

Feed pellet mill: generally need high temperature, easy to ripen, low pressure and high output. Generally use flat die pellet mill and ring die ring die machine

Biomass pellets are made from biomass material by means of a pellet mill. As a hot clean energy source in the market, pellet fuel not only provides more options for energy use, but also a new way to make money. Pellet fuel has many uses, such as biofuel, animal feed, power generation and fertiliser. Strictly speaking, there are still differences between biomass pellet mill and pellet feed machine

1, tempering time, comparing the two units will find that the feed pellet mill has a longer tempering time, even more than two layers of tempering. Because of the higher temperature requirements of the temperer for feed production, high temperature sterilization requires a longer heating material flow

2, the general biomass pellet mill pelleting die is placed horizontally, and the depth of the die hole is shallow. While the pellet feed machine pellet mould is generally placed vertically, the mould is thicker, placed vertically, and the die hole is deeper, giving greater pressure in the process, which not only ensures the forming rate, but also completes the temperature control when making pellets, avoiding the temperature being too high. A careful comparison also reveals that the difference in diameter between the inlet and outlet of the pellet mill is also greater, which is more conducive to pressurisation.